ZINUS Keenan Metal Mattress Foundation, King

This is not the best value for money. While you can put together the bed, the instructions are far too short to be clear and the design of the bed leaves a lot to be desired. For example, when putting together the side of the bed, you need to screw together parts that fit into each other in a male-female slot fashion. One would expect the screw hole holding the things together to be a round hole so the screw stays in place. Instead, it is a cut in the metal and it is possible to pull the two parts apart even after they are screwed together. Things didn't fit together perfectly at right angles and there was some force required to get the various parts to align together to form the frame. I am sure this introduces stress in the metal frame which is not good for the life of the product. The cover that goes over the frame was shorter than expected and tore at one corner while I was trying to put it on top of the frame. The stands are made of plastic, which in reality looks pretty cheap. It would have been better if these were made of metal. The headboard parts are pretty much useless as I don't think any headboard will fir into the narrow space left between the metal headboard latch and the bed. The slats that go into the frame at the top are all the same size, but two of them were supposed to go into slots at either ends of the bed. These slots lie on the curved corners of the frame and are shorter than other slots. It's a lot of pain and hammering before the slats fir into these smaller slots. Some of the nails stick out behind the cover as one of the pictures shows. Some of the parts also had scratches; I am not sure if I was shipped a used product instead of a new one. I would not recommend people buy this product. I am not returning this only because of the hassle of taking it apart, packing it back, and transporting it to a postal carrier. Not worth its cost.