Storage Maniac 2-Tier Under Sink Rack

There were a lot of issues assembling this. Unfortunately, I had everything under my sink strewn around the kitchen before I began, so I stubbornly made it work instead of putting it all back in and returning the shelf. For one thing, the inner telescoping rods were stuck inside the outer rods so I had to remove the connectors to get them to come out and telescope. The connectors clip in place and I was unable to get them to clip back in. Still works, just doesn't look as nice without the connectors that bridge between the two telescoping pieces (the connectors also would protect it from falling apart if I pulled it too far). The screw plate in the end of one of the rods was off at a 30-45 degree angle. Somehow I was able to screw it in, and then bend the whole pole to get it to line up. I had to finish the assembly inside the cupboard so that the rods would be in place within all the drains and hardware under the sink, and that was somewhat difficult, but not as much of a hassel as the previous issues I mentioned. The little shelf parts that go inside are a good idea but they don't sit flat, so some smaller bottles and such would fall over if placed on them. For such a simple little shelf, it was a much bigger job than it should have been. In the end, it works ok and looks better than the plastic bins I had under the sink, but it wasn't as ingenious a solution as I had hoped. Still, it's done and it's in there, so it's staying.