SONGMICS Heavy Duty Clothes Garment Rack

I ordered two of these racks and am surprised at how sturdy they are and how easy they are to put together. Note: The threaded bolts and Allen bar are in the plastic bag. Check the bottom of the boxes with the wheels for the wrench. Putting this together is very quick and easy. I put it together for the first time in under 10 minutes. You do not need any other tools. I recommend the following steps if one person is putting it together. Note: The instructions are very easy to follow. One Person Installation **Put the wheels on LAST ** (1) Go to Assembly Step 2 - Get the 2 Poles Shaped like the letter C (Part A) and the 2 poles shaped like the letter L (Part B). Get the Allen Bar and 4 threaded bolts. Put the L Shaped pole on an elevated flat surface and overhang the short part so it lays flat with the holes facing up. (I did this on our bed as it is going into a bedroom. Guys, Make sure your wife is not home if doing it this way!) Take the Pole shaped like a C and put the bracket over L shaped pole so the holes line up. (Make sure the C is facing down or away from the long side of the L pole). Secure the bracket with the threaded bolts and tighten with the Allen bar. Do this for both sections and then stand the brackets up on their own. (2) Go to Assembly Step 4. Get the two long poles, Part D of equal size. These poles have a thicker and thinner side with a button on both sides. Put the skinny side down and insert into the top of the L Shaped pole from the prior step. Press the button to get the bar to insert. The button will pop out of the hole further down the pole with a "Click". Make sure the button is all of the way out. Do this for both sides. The brackets are still standing but just longer! (3) Go to Assembly Step 3. Place the brackets so the L Shapes are facing each other several feet apart. Install the bottom pole (Part C – Remaining pole with two buttons) with the button facing down. Again, the button must be pressed in to insert the pole. Wait to hear the "Click" to make sure it is locked. I had to wiggle this a little to hear the “Click” (4) Go to Assembly Step 5. Install the Top Pole. Be careful, if the pole is tilted, the top extension pieces will extend out and may hit something. Line up the pole on both sides evenly and push down until both sides rest on the button. Push in the button on one side and push the pole down a little so the button stays pushed in. Go to the other side and do the same. Then push the entire bar down evenly. Listen for the “Click” to make sure the buttons are locked. I had to wiggle this piece a little as well to get both sides to “Click”. (5) Install the wheels. I laid this across an elevated flat (Bed) surface so I could access the base and install the wheels easily. Make sure the two locking wheels are on the same side. Put the threaded part of the wheels into the hole on the bottom of the Legs or C Shaped Pole. You can use the wrench to tighten the threads but it is easier if you just spin the flat metal part with your hand. Then, you only need the wrench to tighten the wheels but I did not need it at all. (6) Put the entire assembly down as it is ready to use. This was very easy to put together. It took more time to write this review! Again, very sturdy and very well built.