TURBRO 18,000 BTU Ductless Mini Split AC, 230V

I have never seen one of these get shipped somewhere without getting half destroyed, mine was no exception. This was my first experience of installing one of these units. When you order it you will need several tools and accessories that are not included and they do add up. You will need a vacuum pump and a gauge set to evacuate the line set before releasing the gas. You will also need a way to mount the outside unit to the wall or on the ground. The last thing is you will need a 20 amp 240v circuit free for this unit and an outside disconnect near the outside unit as per code. This all added up to around $300-400 depending on the quality you select of course. Also this is considering you doing the whole job and not hiring someone to do any part of it. You will need a 2 7/8 “ hole saw for the rubbing to go through the wall as well as an extra long 1/4” drill bit to make a pilot hole. Getting to the actual review of the unit and such it’s not too bad I have had it up for about a week now and I like it but I haven’t been able to get it to connect to my app yet. The inside unit comes with all metric copper lines pre installed that are soldered to imperial fittings and the extension lines are all imperial the tubing and the fittings. The extension tubing is different quality it is much cheaper and does not bend almost at all without kinking look at pictures if you would like to see. I bought a professional grade hvac bender and no matter what I couldn’t get it to bend more than just a few degrees let alone to get it to 90 like I wanted. It cools well and heats well. So if you’re willing to go through a few headaches of the install then it is worth the 1k I would say.